A. major diameter
B. minor diameter
C. pitch diameter
D. core diameter
E. none of the above

Advertisement

Related Mcqs:

  1. If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
    A. square B. acme C. buttress D. BSW E. metric...
  2. A self locking screw has________________>
    A. fine threads B. coarse threads C. coefficient of friction > tangent of load angle D. hole for inserting split pin E. two nuts for locking...
  3. For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
    A. ISO metric thread B. acme thread C. square thread D. buttress thread E. British Association thread...
  4. For tight leakage joints, following type of thread is best suited ____________________?
    A. metric B. buttress C. square D. acme E. NPT (national pipe threads)...
  5. If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
    A. lOVZ B. 10VZtol5Vd C. 15Vdto20VZ D. 20Vdto30Vd E. 30V5″to40Vd...
  6. If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
    A. 102 d B. 124 d C. 138 d D. 151 d E. 168 d...
  7. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?
    A. 0.01 micron B. 0.1 micron C. 1 micron D. 10 microns E. 25 microns...
  8. If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?
    A. 0.2 B. 0.25 C. 0.50 D. 0.6 E. 0.75...
  9. Form coefficient of spring is _____________________?
    A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. concerned With strength of wire of spring E. nothing...
  10. Jam nut is a locking device in which _____________________?
    A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly in middle of nut and then slot reduced by tightening a screw C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as...
Advertisement